Top 5 handmade embroidery tips for beginners

Choosing your fabric

It’s perfectly possible to embroider onto all kinds of fabric – even stretchy varieties if you use a suitable stabilizer. It’s fair to say though that this would be quite an unusual choice for hand embroidery! We thought it would be useful to have a quick round up of the main things you should consider when deciding which fabric is right for your project, which you can read here. After all, like canvas for a painter, the fabric you choose to stitch on forms the foundation of your embroidery and it’s so important to choose carefully.

Transferring your design

Before you can get started you’ll need to transfer your chosen design onto your fabric. You can do this in a number of ways; by tracing your design, using Dressmakers Carbon paper, Prick & Pounce, using a transfer pencil or our favourite method – using Sulky Sticky Fabri Solvy. We’ve written a whole guide to using Sulky Sticky Fabri Solvy to transfer your design which can read here.

If you’re embroidering a design from one of our kits then you won’t need to worry about transferring your design as we include pre printed panels!

Choosing your hoop

To hoop, or not to hoop, that is the question! I know there are many stitchers who don’t use a hoop, perhaps because they find it awkward to hold, too much trouble to move around their work, or simply have tried using one but just didn’t get on with it. And lots of those stitchers produce lovely work without one – but the majority of us find our work is much neater and goes much more smoothly when we hoop up before beginning to stitch.

Using an embroidery hoop is the easiest and handiest way to keep your stitch tension correct (frames are possibly even better, but not always as portable and certainly more expensive). Your hoop has to hold your fabric tight and taut while you work to achieve this – but beware – not all hoops are the same, and some are (much) better than others. Read our guide to choosing your embroidery hoop here.

Threading your needle

This isn’t always straightforward to do – and I was always taught to hold the needle in my right hand (I am right-handed) and with my left hand loop the thread over the point of my needle and hold it tightly. Then, with this loop held firmly between my thumb and first finger, I turn my needle around, place the eye over the loop and push it down so that the thread passes through it.

Starting & Finishing your thread

A good length for your thread is the distance between your wrist and elbow – though a little longer is fine. But don’t cut your thread too long as it may twist, knot and/or fray. I usually start my work with a few small stitches, leaving the end of the thread at the front, within the space on the fabric I’m going to be covering with stitches. After the thread is covered, then I snip off the length at the front. That’s just for the first thread, after that I simply run the thread under a few stitches at the back of my work before I start to stitch.